djohns Posted September 16, 2010 Report Share Posted September 16, 2010 I have a brand new milli and I want to by R&S designer boards for my machine. I have been told that the machine can not roll over them that you have to raise the machine. Help, is this easy to do and should I pursue buy the boards. Thanks, Denise Link to comment Share on other sites More sharing options...
nora123 Posted September 16, 2010 Report Share Posted September 16, 2010 I would try before you think about raising your machine. If you had the basic circlelord system then you would have too. Just install the stylus Ron makes and I think you will be ok. Blessings,Nora Link to comment Share on other sites More sharing options...
GrandmaLKB Posted September 16, 2010 Report Share Posted September 16, 2010 I ran into that same problem not long ago. I ended up replacing the black boards on the table with thinner plexiglass and it works just fine. I didn't need much more height to clear the boards and that 1/8" or so was all it took. I think the black boards were a good 1/4" thick and I got 1/8" thick plexiglass. The other route would be to raise the whole machine by putting extra washers in the wheels, getting Edgerider or M & M wheels. THEN you also have to raise the roller bars to accomodate the added height. The APQS people can give you more information on all that. I was looking for a simpler solution. The plexiglass did the trick for me. I got it in 3 sections so it was easier to handle AND so it would fit in my car to bring it home. haha Link to comment Share on other sites More sharing options...
djohns Posted September 16, 2010 Author Report Share Posted September 16, 2010 Thanks so much, I will go the plexiglass route if it doesn't fit. Thanks, Denise Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.