Tford Posted May 23, 2014 Report Share Posted May 23, 2014 I could raise the hopping foot on my old 2004 Millie but the one I got in January 2013 doesn't have the same opening. I don't normally do "thicker" quilts but this is a t-shirt top with batting and a fuzzy blanket back. The t-shirts tuck as I try to go across and create a pleat. Any suggestions ?? Link to comment Share on other sites More sharing options...
Tford Posted May 23, 2014 Author Report Share Posted May 23, 2014 Nevermind, I found my reference book -- it's on page 203 (Appendix H) in case you're needing to know. You have to remove a cover over the hole -- it's right where it was before but covered! Yea! Link to comment Share on other sites More sharing options...
BobbieJones Posted May 23, 2014 Report Share Posted May 23, 2014 Funny you should ask. I had the same question this week. I called Amy and she emailed me the instructions. Couldn't see any slot in a screw looking thru the tiny hole. It ended up that the screw was laying inside my machine and I never did manage to adjust the foot. It would not move. I did put the screw back in. I wonder how long it's been laying inside my machine? I had to return the quilt to my customer. Link to comment Share on other sites More sharing options...
Tford Posted May 24, 2014 Author Report Share Posted May 24, 2014 Wow, BobboieJones, I would have never found that screw in your machine! I had to take off the left side plate and put a little flashlight in there to be able to see the screw from the little hole on the right side. Even then I was reaching in with my finger to locate the screw.before I could get the screwdriver in. But got it done and got the quilt finished -- and learned something new! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.