Jump to content

stitch length vs. dial setting


Recommended Posts

Hello,  I am a novice with a Lucey.  I have noticed a discrepancy between the actual stitch length and what the dial is set at.

With the dial set at 15, I am only getting 9.5 or 10 stitches per inch.  The stitches are consistent, 

Is there an uncomplicated fix for this? 

Thanks for any help,

Barb

Link to comment
Share on other sites

You can call Amy to ask. That's a big discrepancy. 

Mark a two inch square on a scrap sandwich and stitch it out. Count your stitches and see if they are consistently inconsistent. If you have more or fewer going in one direction, make a note for when you call. Also, stitch a circle and see if the stitches are the same. Sometimes an encoder wheel needs to be snugged.

 

I believe there are adjustments to a board that will remedy this. You might need to be talked through it or may need to replace a board.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...