Dara in IA Posted June 28, 2016 Report Share Posted June 28, 2016 Seems I just didn't have the needle inserted all the way....jeesh.... I have Lucey with M bobbin...I am not sure what needles I should be using. I purchased the machine used, and the needles that were included are GrozBeckert 10 Nm 110/18 134MR 1955MR 134 SAN11 DP X 5 MR. When I put one of these in, press the needle down to pull up my bobbin thread, it 'jams' in the hole, the machine hums, and I have to turn off the power and use the hand wheel to bring the needle back up. Can you tell me, is there something I am doing wrong? Is this the right needle? I think now I have in a needle that I used when I had my Lenni with L bobbin, not sure the brand but they say 1955-01-MR4.5 SET/R 134 135X5 797 DPX5. I know the 4.5 is larger than I want to be using, but it's all I have other than the GB needles. Thanks for any help you can be! Dara in IA Link to comment Share on other sites More sharing options...
Tellabella Posted July 5, 2016 Report Share Posted July 5, 2016 Not sure...did you solve the problem? Link to comment Share on other sites More sharing options...
Dara in IA Posted July 5, 2016 Author Report Share Posted July 5, 2016 Yes, Tellabella...I just didn't have the needle pushed up far enough...I was tired and frustrated and just didn't pay close enough attention.... Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.