Marie E Posted December 13, 2016 Report Share Posted December 13, 2016 Millie sounds as if machine motor is jammed - needle will not go up/down - wheel very stiff/hard to turn. It initially started by needle/machine hesitating. Was using Compuquilter when first noted something wasn't quite right so disconnected computer and then tried manually when it just got worse. With needle being very slow to respond and now will not go up and down hardly at while machine motor sounds stuck. No support in Tasmania, Australia so any suggestions/advice would be greatly appreciated. Have emailed APQS support Thank you! Link to comment Share on other sites More sharing options...
jimerickson Posted December 15, 2016 Report Share Posted December 15, 2016 Marie: Sounds like you might have thread wrapped around one or more of the mechanisms that's binding the machine. Go over the machine carefully looking for any such thread. Jim Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.