kacklebird Posted January 14, 2012 Report Share Posted January 14, 2012 Hi, Can Accuquilt Go Dies be used in the Accucut Mark IV cutting machine? Your help is GREATLY appreciated. Thanks Link to comment Share on other sites More sharing options...
carolinequilts Posted January 14, 2012 Report Share Posted January 14, 2012 If you go to the Stitch in the Ditch site (it is Canadian), they sell adaptor boards for Go Dies. You can call them and they will help you pick out the right one. You can also go to the AccuQuilt site. They have a new adaptor board to fit Go dies on the Studio cutter. The Studio cutter is the same as Mark IV, and I think it is the same as the Big Shot Pro (Sizzix). Hope this helps. Link to comment Share on other sites More sharing options...
srichardson Posted January 14, 2012 Report Share Posted January 14, 2012 This old thread may answer your question. I haven't re read the whole topic so I could be wrong. http://www.apqs.com/quiltboard/viewthread.php?tid=24483&page=1#pid306849 Link to comment Share on other sites More sharing options...
cblevins Posted January 14, 2012 Report Share Posted January 14, 2012 I ordered the adaptor to fit my Studio but it isn't here yrt. Link to comment Share on other sites More sharing options...
cjtinkle Posted January 15, 2012 Report Share Posted January 15, 2012 Yes the adaptor works just fine. I was thrilled to see it released because I can buy the GO dies at wholesale, and so now I purchase any specialty dies I won't use a lot that way. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.