elkayr Posted March 28, 2013 Report Share Posted March 28, 2013 my light bar is so loose. the screws are as tight as possible without bending something. does anyone know what causes that? Link to comment Share on other sites More sharing options...
mark Posted March 28, 2013 Report Share Posted March 28, 2013 Linda, Do you have the light bar that has the round tubular steel? If so there are Allen screws at each of the points where the tubes hook together so you might check to see if you have those tight there is a screw on the top of the tube and the bottom on each place. Hope that helps! Link to comment Share on other sites More sharing options...
RunningThreads Posted March 28, 2013 Report Share Posted March 28, 2013 Linda If you have the flourescent lamp there are a couple of screws holding it to the aluminum block. You would have to remove the bulb undo the nuts and bolts hold the sockets and then the cover hiding the wire comes off and the screws are in there. Are theses the ones you are tightening? There are also screws behind the handle holding the aluminum block on but if these were loose you would be complaining about the handle wobbling. Nigel Link to comment Share on other sites More sharing options...
elkayr Posted March 28, 2013 Author Report Share Posted March 28, 2013 I was going to post a pic but forgot how. Anyway, I called it the light bar but the handles are also loose. There are 4 black knobs in the center of the light bar/handles. And they are tight. I will try to get a pic posted. Link to comment Share on other sites More sharing options...
elkayr Posted March 28, 2013 Author Report Share Posted March 28, 2013 Here's the photo. Link to comment Share on other sites More sharing options...
mark Posted March 29, 2013 Report Share Posted March 29, 2013 My bad! I thought you were talking about the overhead lighting. Nigel is right if you take the 4 black thumb screws off on the front of your handles so you can swing your curved handles out of the way, you will see 2 Allen head screws that hold the Aluminum block to the front of the head. Tighten those up and you should be good! Link to comment Share on other sites More sharing options...
elkayr Posted March 29, 2013 Author Report Share Posted March 29, 2013 Thank you so much Nigel & Mark. Linda Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.