rbeason Posted August 25, 2013 Report Share Posted August 25, 2013 just installed my quilt path tried to do a sample block stitch and nothing works. when set up for quilt size then the block it goes out of range what to do? Link to comment Share on other sites More sharing options...
JeannieB Posted August 26, 2013 Report Share Posted August 26, 2013 Make sure your QP clamps are engaged. Link to comment Share on other sites More sharing options...
Laurajerri Posted March 21, 2015 Report Share Posted March 21, 2015 JeannieB, you mentioned your QP "clamps". I had one clamp that was pre-installed when I opened the box. Should there be two? Do you have a picture or tell me where to see this. Thanks. Link to comment Share on other sites More sharing options...
HeidiP Posted March 22, 2015 Report Share Posted March 22, 2015 There should be a clamp with a red handle that secures the horizontal belt, on the front of the carriage, and also one to secure the vertical belt, located on the left of the carriage. Hope that works. I'm having fun getting to know Quilt Path too! Link to comment Share on other sites More sharing options...
JeannieB Posted March 22, 2015 Report Share Posted March 22, 2015 here's the clamps (disengaged) from the side ... Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.