Michael Spieker Posted April 9, 2014 Report Share Posted April 9, 2014 I'm on my third row doing a panto in EZ mode and I am getting jump stitches across the top of my panto. This is happening despite my best effort to eliminate the jump stitch on the optimization page. What am I doing wrong. Question two: is it possible to access the optimization page after a row is started then stopped before the row is completed ? Link to comment Share on other sites More sharing options...
Michael Spieker Posted April 9, 2014 Author Report Share Posted April 9, 2014 I'm not sure if what I'm describing is properly called a jump stitch or not. Whats happening on the top of the panto is the motion is stopping then tying off when moving over a bit then starting up again. This happened with my first row which I don't mind but I can do without the stops and starts. The second row quilted out to completion just fine without this hassle,but now my third row is behaving like the first row with the starts and stops. I would like to entirely eliminate the need to "Move To Next" when doing pantographs. Link to comment Share on other sites More sharing options...
zeke Posted April 9, 2014 Report Share Posted April 9, 2014 Do you have it on staggering. zeke ... Link to comment Share on other sites More sharing options...
Michael Spieker Posted April 9, 2014 Author Report Share Posted April 9, 2014 @ Zeke. No. I think I figured it out. I was toggling the upper left corner button after manual placement. I eliminated this step and everything is quilting good as it should for now. Link to comment Share on other sites More sharing options...
zeke Posted April 10, 2014 Report Share Posted April 10, 2014 Cool. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.