DebY Posted November 15, 2017 Report Share Posted November 15, 2017 I recently moved my Millie with the my Compuquilter. I had my Millie serviced during the move and an “L” bracket was removed from the bottom of the Millie. Does anyone know where to screw it back onto the bottom of my Millie, or can you post a pic of where this black bar sticks out from their Millenium? I think it is the sensor bar to tell Millie to stop sewing. Help, help, help please. Link to comment Share on other sites More sharing options...
zeke Posted November 16, 2017 Report Share Posted November 16, 2017 Hey Deb. It should be connected to the front axle on both sides. I think you're talking about the one on the rear correct? I don't have mine set up right now or I would send you a picture. I'll see what I can do. Zeke. Link to comment Share on other sites More sharing options...
DebY Posted November 16, 2017 Author Report Share Posted November 16, 2017 Zeke, Thanks, I thought that it was from the front axle, but should the bar point forward or toward the back of Millie? I assume toward the front? Link to comment Share on other sites More sharing options...
zeke Posted November 16, 2017 Report Share Posted November 16, 2017 If it's the back sensor then it should point towards the back. The front should point towards the front. Zeke. In some cases the axles are placed differently then other machines. Mine are more towards the middle of the machine which allows me to do a 17 1/2" panto. I also have a square tubing table which is a little more forgiving then the round. The leveling bar is a tab bit adjustable where the round tuning table is not and I can also adjust the belly bars. Link to comment Share on other sites More sharing options...
DebY Posted November 16, 2017 Author Report Share Posted November 16, 2017 Thanks Zeke, Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.