catsigler Posted July 19, 2007 Report Share Posted July 19, 2007 Holy CARP!!! Now what!!! Trying to raise the table so I can see around the light and the wheel falls off, which means the other three are maybe a half turn from falling off. Apparently I can only raise the table 1" if the wheels are installed. Update: I got the wheel back on with my tire jack and managed to raise the table a couple of inches and level it again. Thanks for the help. Next I want to remove the thread cutter, but not today. Link to comment Share on other sites More sharing options...
Mary Beth Posted July 19, 2007 Report Share Posted July 19, 2007 huh:o I don't get it....You should be able to raise the legs... Link to comment Share on other sites More sharing options...
mark Posted July 19, 2007 Report Share Posted July 19, 2007 Hey Cat, You will see a very large nut that fits up against the bottom of the leg. You need to loosen this as there is a threaded rod insert that the casters screw into, this is what will unscrew out of the bottom of the legs about 9". You then screw the large nut back up against the bottom of the leg to snug it back up so it won't move out of place. If you don't understand what I am saying, call in and speak to Amy and she can walk you right though it! Take care, Link to comment Share on other sites More sharing options...
Stagecl Posted July 25, 2007 Report Share Posted July 25, 2007 I removed my lower thread cutter. It was a feature I didn't use and it did make the millie lighter. It isn't hard to remove. Cheryl Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.