Jump to content

hopping foot and bar


tsurich

Recommended Posts

Is there an update on the hopping foot that does not have the weld bump at the back of the foot? I have a Liberty. Been trying to use Off the Edges circle maker where foot slips through channel in template then runs around the inner part of circle. Kept getting circles that are flat on one side and realized the weld gets in the way. Husband is thinking of machining that bump off somehow. Is that safe? I may need a replacement if all isn't well. Also cost of the updated foot or even the original type if DH goes at that bump.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...