LinE Posted December 24, 2005 Report Share Posted December 24, 2005 I had a lot of thread wrapped around the bobbin case, I was going to take it out, but could not figure out how to do that, I got as far as removing the top black bar with the hook on the end, I got all the thread out with tweezers, but I forget if the black bar w/hook faces up or down? I just need to screw it back in but not sure which way it goes? Link to comment Share on other sites More sharing options...
Myrna Ficken Posted December 24, 2005 Report Share Posted December 24, 2005 the little "hook"goes up about 1/3 of the way into the slot. Myrna Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.