jchabott Posted April 5, 2011 Report Share Posted April 5, 2011 My Milli is sticking (sort of). Whether I'm quilting, then stop, or pulling the thread up with needle up/down, the machine is not stopping. It will continue in the slow mode of needle up/down... and nothing will stop it. I appreciate any suggestions of help. Thank You! Link to comment Share on other sites More sharing options...
witha'K'quilting Posted April 5, 2011 Report Share Posted April 5, 2011 You need to adjust the #8 screw under the top hood cover. Link to comment Share on other sites More sharing options...
barbm Posted April 5, 2011 Report Share Posted April 5, 2011 jchabott, check the reply on your other thread. Link to comment Share on other sites More sharing options...
ffq-lar Posted April 5, 2011 Report Share Posted April 5, 2011 It's an easy fix and you will feel great when you are able to adjust things yourself. Unplug the machine. Remove the four forward screws--two on each side of the hood. Loosen the two back screws only enough to lift the hood. Look for the gold screw on the right side--the only one facing out instead of up. Use a screwdriver to adjust. Righty--faster up/down Lefty--slower up/down--the one you want. Lower the hood, plug in and test. Re-adjust if necessary. Replace and tighten the hood screws. Make sure you warm up (run at least 5 minutes) before adjusting or you will find you need to adjust again. Good luck and enjoy the feeling of fixing your machine yourself! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.