elviraquilter Posted May 2, 2011 Report Share Posted May 2, 2011 Sorry, posted wrong under 'Poll'. My stitch regulator only works up and down, not left to right. I think I cleaned everything really good. Help! Lots of customer quilts to do! Link to comment Share on other sites More sharing options...
Quilting Heidi Posted May 2, 2011 Report Share Posted May 2, 2011 You should check your encode wheel to make sure it is engaged and also check the connection to make sure you have it plugged in and didn't pull it lose. If that doesn't work call APQS as it might be a board problem. Link to comment Share on other sites More sharing options...
elviraquilter Posted May 2, 2011 Author Report Share Posted May 2, 2011 The only thing I can find is that the horizontal little wheel moves easier than the one for the vertical movement. Everything seems to be plugged in. I left a message for Amy but haven't heard back. Link to comment Share on other sites More sharing options...
Butterfly Posted May 2, 2011 Report Share Posted May 2, 2011 You can loosen a screw and push the encoder wheel into your machine wheel so the encoder fits more snuggly, then tighten the screw up again. Hopefully its that easy. Jess Link to comment Share on other sites More sharing options...
srichardson Posted May 3, 2011 Report Share Posted May 3, 2011 Elvira, If you subscribe to the APQS e-mail newsletter there are instructions in e-mail today about how to deal with stitch regulator issues. Good luck, Sue PS I just forwarded a copy to your e-mail. Link to comment Share on other sites More sharing options...
RoseCity Quilter Posted May 3, 2011 Report Share Posted May 3, 2011 Hope your up and running soon my friend.... Link to comment Share on other sites More sharing options...
elviraquilter Posted May 6, 2011 Author Report Share Posted May 6, 2011 I needed a new encoder for the back wheel. My Millennium is running again! Thanks for all your suggestions, and thanks to Dawn for all her help! Link to comment Share on other sites More sharing options...
DawnCavanaugh Posted May 6, 2011 Report Share Posted May 6, 2011 :) Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.