Dara in IA Posted August 15, 2011 Report Share Posted August 15, 2011 Moved my machine, set up, everything nice and level, stitch regulator working perfectly....BUT....the machine seems to want to 'buck' nose up when I get too far back towards the back rail. Was basting across top and noticed that front wheels were 'light' to the point of no contact with rail. Anyone have any suggestions? Link to comment Share on other sites More sharing options...
Dara in IA Posted August 15, 2011 Author Report Share Posted August 15, 2011 PS - I am not really a newbie, just can't remember my previous log in/password....jeesh... Link to comment Share on other sites More sharing options...
jeri Posted August 16, 2011 Report Share Posted August 16, 2011 Heidi can re-set your old one. Just e-mail her. Is your table level front to back as well as lengthwise? Even a little off can cause problems. Link to comment Share on other sites More sharing options...
CrazyAboutQuilting Posted August 16, 2011 Report Share Posted August 16, 2011 Dara, are you sure that you have your Lenni mounted correctly on the little platform? Sounds like two of the wheels aren't where they are supposed to be so they are able to raise up off the platform....... Link to comment Share on other sites More sharing options...
Dara in IA Posted August 17, 2011 Author Report Share Posted August 17, 2011 My table is more level than it has ever been...was on carpet, now on tile floor. It is level both front/back and side/side. Marilyn, I don't think there would be any other way to put it on. It is the wheels of the platform that are lifting up....no on the machine. Guess I'll give Dawn a call or someone in service and see if they can talk me through it.... Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.