whitepinesquilter Posted June 5, 2012 Report Share Posted June 5, 2012 Here's the back of the carriage on my Ulti I. The back axle makes a huge difference in stability of the head. I can't get two pictures on at the same time so I didn't get a pic posted here of the adjusting nuts on the front wheel mounts. The only thing we had to change was drill and tap a screw hole on the front of the carriage where the wiring mount is for our Intellistitch for the wheel that rides on the table rail. Link to comment Share on other sites More sharing options...
cmkeindl1 Posted June 5, 2012 Report Share Posted June 5, 2012 Thanks Marci, I see now So is the length of the carriage any different than the old ones or more the placement of the wheels (for balance) in the front? Link to comment Share on other sites More sharing options...
cmkeindl1 Posted June 5, 2012 Report Share Posted June 5, 2012 I'm not sure, but my wheels are directly underneath the sides? only other question is the fact that my front and back axles are far apart? Link to comment Share on other sites More sharing options...
whitepinesquilter Posted June 5, 2012 Author Report Share Posted June 5, 2012 Cathy, sent you a u2u Link to comment Share on other sites More sharing options...
whitepinesquilter Posted June 5, 2012 Author Report Share Posted June 5, 2012 The wheels on the front are in the same place, the back wheels are just located on the axle instead of the carriage (with the axle being mounted on the carriage where the wheels were on the old carriage). There is no difference in the distance between the front and back wheels. Hope that makes sense. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.