Jump to content

Table is level on legs, but not on hydraulic lift

Recommended Posts

Okay...I'm moved in.   Millie is mostly set up.   I got her levelled perfectly on her legs.   When I use the hydraulic lifts however, the level is slightly off.  I am trying to figure out how to get my two left hydraulic lift legs to go 'into' the mechanism by about 1/4-1/2'',  without affecting the table legs.   The feet ends are already totally screwed in, so I can't adjust that by screwing the base feet a little.   any takers on this one? 


I don't want to touch the right hand side of the table because everything is level over there. It's just the left side that is ever so slightly off.


The legs are already 'out' and don't go all the way in to the base of the mechanism, when I push the button to do that.  

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Create New...