Quilt path won't plot safe area

[Sjamey 0]

I was quilting away when my needle broke and Millie started acting up...I quickly stopped the machine and fixed the needle. I have not been able to get started again because the safe area will not set. I have turned everything off, checked everything I can think of and nothing helps. Any suggestions?

[barbm 330]

When you fixed the results of the needle break, did you happen to unclamp your clamps?  If they aren't firmly secured, you won't be able to set the Safe Area.

Another place you can come for Quilt Path help (with a more immediate response) is our Quilt Path Users Group on Facebook.  If you're on Facebook, find me there (Barbara Mayfield - Barbara Jeanne Potter) and send me a Friend Request.  Once I've verified that you're an APQS owner with Quilt Path, I can add you to the group.

[Sjamey 0]

Thanks for responding. I did check the clamps and they are ok but I also re-clamped them. I sent a friend request on Facebook

[DebbieAllen 0]

I'm having the same issue.  I just installed my table and quilt path and wondered if I needed to snug up my belt drive on the front of my table some?

[Jmiles73 0]

I also am having an issue setting my safe area. I friend requested you also to be added to the quilt path page. I purchased my machine from Brenda Shreve in Barnsdall Ok. She is great. 

 

[barbm 330]

Julie, I've accepted your Friend Request and added you to the QP Facebook Page.  On your safe area check a couple of things: that the clamps are fully engaged, that you're not in Simulation Mode, that your cables are all plugged in.  Can you post a photo of the screen you see when it says your Safe Area is not set?  Maybe on the QP FB page?

[SewAmy 0]

Just got a new Millie 30 and having the same problem with QP recognizing the safe area

 

[barbm 330]

Are you on the QP Facebook Page? And re: your issue: first thing to check are your clamps - are they fully engaged? That would mean straight up and then a bit over the top to lock - both of them. Is the stepping motor mounted on your table plugged in?  There are two cords that run from your power "bundle" to that motor - one has a molex (white) connection, the other has a phone cord-type connection.  Unplug both of those and replug them to make sure they are fully seated.  Then do the same thing with all the plugs that are plugged into the back part of your carriage - unplug and replug. All this should be done with your carriage, head and QP powered down, then start everything up, in that order - carriage on (switch lights up), head powered on, then tablet powered on.  Set your clamps and engage QP. If none of that works, call APQS Service in the morning and describe each step that you've taken.  Better yet, get on the QP FB page and get help ASAP.  To do that, send a friend request to one of the admins - myself, Heidi Patterson or Angela Hugli Clark - and we'll get you added.  Your APQS Rep should be able to add you, as well.

[Janae 0]

On 2/11/2017 at 11:42 PM, barbm said:

When you fixed the results of the needle break, did you happen to unclamp your clamps?  If they aren't firmly secured, you won't be able to set the Safe Area.

Another place you can come for Quilt Path help (with a more immediate response) is our Quilt Path Users Group on Facebook.  If you're on Facebook, find me there (Barbara Mayfield - Barbara Jeanne Potter) and send me a Friend Request.  Once I've verified that you're an APQS owner with Quilt Path, I can add you to the group.

I would like to be a friend on facebook.  I sent a friend request.  Thank you