dpfemia 1 Report post Posted August 26, 2018 Returned millie to frame after service for removing burr, now hand controls do not work and front panel comes on but needle up/down buttons do not work and only way in start machine is with the stitch regular. please help me Quote Share this post Link to post Share on other sites
Kueser 51 Report post Posted August 26, 2018 check your connections. You may have a bad cable. Quote Cee K Share this post Link to post Share on other sites
dpfemia 1 Report post Posted August 26, 2018 all connections seem snap in, is replacing the cable the way to know if its bad? thanks Quote Share this post Link to post Share on other sites
srichardson 240 Report post Posted August 26, 2018 Do the controls on the handles at the back work? Quote Share this post Link to post Share on other sites
dpfemia 1 Report post Posted August 26, 2018 Turns out i connected the rear cable to the wrong space, its working now! 1 dbams reacted to this Quote Share this post Link to post Share on other sites
srichardson 240 Report post Posted August 27, 2018 Pleased to hear that you are up and running again! Quote Share this post Link to post Share on other sites
