10 ft rods for a used longarm set I just purchased (APQS wooden table/Ultimate II machine).


Recommended Posts

Just a suggestion:  Take all 3 rollers to the welder/fabricator at the same time.  Have him cut off the end without the gear, and then re-weld the shaft caps after the rollers have been shortened.  Tell him you want them to all be shortened exactly the same amount.  After the rollers have been shortened then take to shortening the actual table top.  With the rollers in hand it will be easier to get the top cut to the right length.  No chance of measuring errors, or communications mistakes.  Good luck.  Jim

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...