CynthiaWilson Posted September 21, 2006 Report Share Posted September 21, 2006 We had to move on short notice and as a result I had a lot of people helping fill boxes. All my quilting stuff, including my assembly instructions are mixed up with a lot of NQR things. I cant find my binder with the instructions, and I am having problems figuring out how to get the railing back into the motorized fabric feed. There is a rubber cushion "thing" that goes between the two sections (one on the rail and one attached to the motor) but I cant seem to get them to be the same height. I know the legs are the same height, because we have to take the extensions out for the table to be the right height (I am only 5' tall). Is there a trick for getting the the rail into place? Link to comment Share on other sites More sharing options...
mark Posted September 21, 2006 Report Share Posted September 21, 2006 Hi Significantcyn, Loosen the 2 bolts that hold the motor bracket to the side of the leg. This will allow you to realign the 2 couplers so it will fit back together. After you have the couplers together again, retighten the two bolts and you should be set! Take care, Link to comment Share on other sites More sharing options...
CynthiaWilson Posted September 22, 2006 Author Report Share Posted September 22, 2006 Yup...that did it for sure! I tell ya... some times I think I am the least mechanical person on earth Thanks for the help, I spect to be back for tension help in another forum once the rails are on and she is ready to drive again. Cynthia Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.