moogiequilter Posted October 20, 2014 Report Share Posted October 20, 2014 I have run into a problem with my Quilt Path. I have broken a needle and when that happens, the x y position of the machine gets off from where it was originally. If I go into fix the pattern and pick the closets stitch, it isn't lined up with where the quilting really is. what I want to do is tell the system 'you are here' essentially and have it start quilting from that point. All I can figure out how to do is use the nudge arrows, but when you are off by an inch or more, that takes a really long time and isn't very accurate. Any help would be appreciated. Link to comment Share on other sites More sharing options...
Georgene Posted October 21, 2014 Report Share Posted October 21, 2014 Perhaps you could go back and place the row again, then pull bobbin and sew for just a couple stitches. Then stop, repair pattern and then go to closest stitch where needle broke. I think I've done it this way before. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.