Carreen Posted September 17, 2011 Report Share Posted September 17, 2011 As I was quilting the needle pulled out of the shaft and was stuck down so I worked it out then put in a new needle and when it goes into the fabric it won't let the needle rise, it's hitting something. Did I knock it out of timing? Thanks for any answers. Link to comment Share on other sites More sharing options...
quiltmonkey Posted September 17, 2011 Report Share Posted September 17, 2011 OK in the future, when you are putting in your needle, be sure you use a long handled screw driver to get enough torque to tighten the screw down properly. The short stubby screw drivers just don't work for getting that screw to tighten down, and the needle will fall out. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.