kathyb Posted September 30, 2004 Report Share Posted September 30, 2004 The light on my Millie often flickers and everytime I brush the back of my hand near there when I'm trimming threads, the light goes off and I have to give it a gentle twist to make it go back on. It's more of a nusance than anything else. I've tried so many different ways to install the light, but it's almost as if it wasn't installed properly. Does anyone else have this problem? Any suggestions as to how I can make it stop? Link to comment Share on other sites More sharing options...
mark Posted September 30, 2004 Report Share Posted September 30, 2004 Hi Kathy, If you take your light out you will see on either end the sockets where the light fits into. Make sure that these are ok. In other words, make sure that the light is fitting tightly into these sockets. If the light pins aren't making contact firmly, when you bump your light it looses contact and goes out. Let us know how it is and contact us if you need further assistance. Good luck, Mark APQS Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.