Barb Barna Posted February 21, 2004 Report Share Posted February 21, 2004 Thanks APQS for the great forum. I was taking a shortcut and used my ruler with out the adapter....bad, bad. Of course the needle bar nicked it, but now I am wondering where the adjustment screw is for the needle bar-it seems to wiggle just a tad. I have a 2 yr old Millenium. In the booklet it says it is under the handles, but I cannot locate. Thanks. Link to comment Share on other sites More sharing options...
mark Posted February 23, 2004 Report Share Posted February 23, 2004 Hi Barb, The screw that we are talking about is behind your front cover,(meter cover). You will have to take out the two screws on each side that holds that cover on. There are wires that will be connected to the cover so you can just lay it over to the side. You will see a hole drilled in the front of your machine. Lower your needle bar by hand to the lowest position and there will be a screw that lines up with the hole. Using a long straight screwdriver reach in and tighten screw. If you have any questions, please feel free to call us @ (800) 426-7233 ext. #6 Hope this will help. Good luck! Mark Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.