APQS used longarm machine

[BethJ]

Hi there, I have seen on this site where a person has commented that you can have a welder cut the rails to make them shorter. Can anyone address this question? I have seen an older longarm, but the rails are too long. If anyone could answer this, I would appreciate it. Thanks

[mark]

Hi Beth,

Yes, a welding shop can cut down the aluminum table rails to whatever size and then they will also need to cut down the fabric rollers.  There is a hub welded into the ends of the steel pipe that can be taken out of one end, cut the pipe to match the table rails and then reweld the hub back into the end of the pipe.  Much cheaper than buying new pieces from APQS.