Jump to content

Recommended Posts

Pull the top thread through the eye of the needle and look at the tension check spring.  It should pull down to about  9 O'clock if it is pulling tighter   to 8 0r 7 O'clock you then need to loosen off your top tension.


You will need a tail on your bobbin thread of about 4".


If you take off your throat plate and  needle up down you may find where the top thread is hanging up, it could be in the bobbin finger - the thingamajig that stops  the whole bobbin assembly from free wheeling - it should only  be 1/3 rd of the way into the hole.  All this is in the manual.

Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...