ncutt Posted February 14, 2008 Report Share Posted February 14, 2008 I want to loosen my front wheels and cannot see the right front nut too good because of the X axis thingamajiggee. Any ideas on how I can make sure the bolts are both turned to the same position? Thanks! Link to comment Share on other sites More sharing options...
TinaCollins Posted February 16, 2008 Report Share Posted February 16, 2008 If you need to see an obstructed view of the camlock on top of the wheel, you can simply remove the X axis lock fixture. First, undue the X lock block and let it fall on the cable (just as if you were going to freehand quilt). Look on the inside of the carriage (right side), and loosen the bolt with a 7/16th wrench. Remove the X lock fixture, adjust the camlock on your wheel, and reattach the X lock fixture. It\'s really easy... You can\'t mess it up!! Link to comment Share on other sites More sharing options...
ncutt Posted February 18, 2008 Author Report Share Posted February 18, 2008 DUH!!!! Thank you, Tina..... Link to comment Share on other sites More sharing options...
zeke Posted March 19, 2008 Report Share Posted March 19, 2008 norma, while your at it, you might as well get a sharpie and mark the nut. this will make it easier to see where to turn it next time. zeke........ Link to comment Share on other sites More sharing options...
ncutt Posted March 31, 2008 Author Report Share Posted March 31, 2008 Thank you, Zeke! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.