Sams Mom Posted April 10, 2008 Report Share Posted April 10, 2008 Hello, thanks for any help. I just replaced my Millinnium head and am ready to use CQ but I don\'t have any limits any more. The carrage connector (y axis) hits the black round assembly at the front (thunk) and the hopping thingie hits the leveler bar in the back. What am I missing? Thanks. Donna Link to comment Share on other sites More sharing options...
Johnmach Posted April 10, 2008 Report Share Posted April 10, 2008 When you replaced the head, did you also replace the carriage? If so, did you replace the sensors and the little black pieces that are the limit sensors? Is the clearance between the sensors and the metal pieces set correctly? Have you checked to see if the cables are connected? Johnmach Link to comment Share on other sites More sharing options...
Sams Mom Posted April 11, 2008 Author Report Share Posted April 11, 2008 Thnaks for the help. We didn\'t replace the carrage. I think that we have figured out that the axels on the new head are not in the same place as the old axels. We will move the middle one tomorrow evening. Hopefully this will fix the problem. I will carefully work without limits until then. Wish me luck. Directions on CQ upgrading as well as installation would be verrrrryyyyy helpful. Donna Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.