smorris Posted March 4, 2007 Report Share Posted March 4, 2007 Hi Nadia First try rotating the thumbwheel until the needle is in its highest position, then press the thread cutter button. The thread cutter will not work if the needle is not in the correct position for safety reasons. I can think of two other things (relating to the Max Speed light); one only involves a small adjustment on the boards so you might need to ring the factory on Monday for instructions on which screw to adjust and how. It is different to adjusting the no 8 pod. Good luck - hope you are up and running soon. Best wishes Sue in Australia Link to comment Share on other sites More sharing options...
Nadia Wilson Posted March 5, 2007 Report Share Posted March 5, 2007 Thank-you very much for your help. I found another fuse on my machine, inside a little round thing on the side, replaced it and I was able to start stitching again. Will call APQS in the morning and go over this with them. Thanks again Sue in Australia for your help. Link to comment Share on other sites More sharing options...
Darlene Epp Posted March 8, 2007 Report Share Posted March 8, 2007 Nadia's machine is up and running. Thanks to Amy! Link to comment Share on other sites More sharing options...
Nadia Wilson Posted March 8, 2007 Report Share Posted March 8, 2007 Yes, thanks to Darlene and Amy my machine is working, have to practice, practice, practice! Thanks for the help everyone, really looking forward to my class! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.