jebm Posted May 15, 2015 Report Share Posted May 15, 2015 My 2007 Millie recently began to lose its power steering feel around the center of the 14' frame. I can move it...but no curves...table is level side to side and front to back. I have worked on the wheels on the front of the frame. I do have an IQ, which doesn't seem to be affected. However I do a lot of freehand, and have 2 king size quilts which will require mostly freehand. I'm at a loss. Any help appreciated! thank you. Jane Michener Link to comment Share on other sites More sharing options...
jimerickson Posted May 15, 2015 Report Share Posted May 15, 2015 I think it is probably wheel adjustment. That being said, check to make sure there is adequate clearance between the machine and the leveling roller. Check to make sure your channel locks are operating properly. Check to make sure that the top of the table is flat end to end. (pull a line tight between one end and the other, and make sure the rails do not bow one way or the other) You may need to readjust your trusses. Good luck. Jim Link to comment Share on other sites More sharing options...
jebm Posted May 16, 2015 Author Report Share Posted May 16, 2015 Thanks Jim, I appreciate and will work with your suggestions. Jane Link to comment Share on other sites More sharing options...
jebm Posted May 27, 2015 Author Report Share Posted May 27, 2015 I just replaced my yellow bearing M & M wheels and life is fabulous - almost blissful! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.