Traded up to a Millie , hits leveling bar

[Livin_the_dream]

Problem resolved 

 

Mark

[RunningThreads]

I’m not sure what table you have without a picture and haven’t looked at new machines in several years but this might be the answer.  On the old deluxe table (I assume it is still the same) remove the Allen bolt at the left end of the leveling bar and then remove the bar from the mounts.  Loosen the lock nuts on the mounts and count the number of turns you unscrew the mount to get to the right height.  Unscrew the other mount exactly the same number of turns, hold the mount in place and tighten the lock nuts, instal bar and test.  When properly adjusted you should be able to to get your index finger up to the first knuckle between the bar and the machine.  
 

Best of luck

Nigel