PattyJo Posted May 31, 2008 Report Share Posted May 31, 2008 When I use my thread cutter, it cuts the thread so short that my top thread won\'t pick it up to begin stitching again. I always have to pull out the bobbin, pull the thread out, put it back in and then maybe on the 2nd try, I can get it pulled up with the top thread. Is there an adjustment for this? Is my thread cutter needing to be sharpened? I\'m at a loss, but I know that this isn\'t right. I\'ve had this problem sometimes in the past, but today - EVERY TIME I had to pull out the bobbin and pull out the thread then put in back in. Geeerrrr! Very frustrating. Can anyone give me an idea of what I should do? Thanks Oh I was using So fine on top and bottom line in the bobbin. Link to comment Share on other sites More sharing options...
sjdanley Posted May 31, 2008 Report Share Posted May 31, 2008 I had that problem for a while. I wasn\'t moving the machine away from the final stitch postion before I used the thread cutter. Now I move it about six inches away before I cut the thread and seldom have the problem. Hope that helps. Link to comment Share on other sites More sharing options...
lindasewsit Posted May 31, 2008 Report Share Posted May 31, 2008 yeh.... what Sharon said!! linda Link to comment Share on other sites More sharing options...
PattyJo Posted May 31, 2008 Author Report Share Posted May 31, 2008 thank you Sharon & Linda - I think my head must have been in LaLa land. I should have known that. I just wasn\'t thinking. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.