cnosburn

Machine is hard to move in manual mode

Recommended Posts

I'm not sure about waxing. Maybe need to do a deep clean on the wheels. Grab a bottle of alcohol and some scrap batting and clean the groves of the wheels and the edges of the carriage. Check the cords to see if they aren't hanging up on something under the table.


Cee K

Share this post


Link to post
Share on other sites

Thanks for your inputs.  I did check  and cleaned the wheels, but not with alcohol, but will do this. I have been in  contact with Dawn at APQS and apparently I will need to adjust the cams on the front of the carriage which I have done, but it made it worse because evidently I did not get them tightened to match. So am waiting on an response from APQS again.  They have to be perfectly matched to work properly.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now