Bonnie in Ok Posted November 26, 2010 Report Share Posted November 26, 2010 I finally got the econozoid and the long arm attachment to do long boards from the front. (YEA!) My question is how do you set up the RnS longboard since the board does not have any holes in it to connect it to the econozoid? Link to comment Share on other sites More sharing options...
Quilting Heidi Posted November 26, 2010 Report Share Posted November 26, 2010 Bonnie, You can either drill the holes into the RnS board or clamp it on. Congrats. Link to comment Share on other sites More sharing options...
witha'K'quilting Posted November 27, 2010 Report Share Posted November 27, 2010 The board just sits on the attachment. I them clamp it to insure it stays where I want it. Link to comment Share on other sites More sharing options...
Bonnie in Ok Posted November 27, 2010 Author Report Share Posted November 27, 2010 Thanks will clamp it to the atttachment. Do you recommend a special type of clamp> Link to comment Share on other sites More sharing options...
witha'K'quilting Posted November 27, 2010 Report Share Posted November 27, 2010 I use clamps identical to the orange ones used for the sides or the quilt. Link to comment Share on other sites More sharing options...
Quilting Heidi Posted November 27, 2010 Report Share Posted November 27, 2010 Kristina, Good idea. I have mine and could use them. I usually steal hubby's small wood working clamps! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.