lnieland Posted April 5 Report Share Posted April 5 Something seems off with my Bliss table. Today I used a laser level to check it a from a few different spots, and it seems that the table is "unsquare" by about 3/8" to 1/2" from one end to the other. I can't find any instructions or guidelines on how to remedy this. Any suggestions? Thanks! Link to comment Share on other sites More sharing options...
jimerickson Posted April 9 Report Share Posted April 9 Are you talking square or level? If it's square, then your frame is "racked" and needs to have the long corner pushed toward the short corner. I don't know exactly how your frame is made, but I'd guess by loosening the bolts holding it together and forcing it toward square, then tightening the bolts, would do the job. You can check squareness by measuring diagonally corner to corner. Your table will be square when the two measurements are exactly the same. If you're talking about level, then adjusting the height of the individual legs should do the job for you. Good luck. Jim dbams 1 Link to comment Share on other sites More sharing options...
lnieland Posted April 10 Author Report Share Posted April 10 Thanks, Jim. The table was not square, and you are right - I had to loosen the bolts and "force" it to square it up. Thanks! dbams 1 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now