Kari Posted May 25, 2009 Report Share Posted May 25, 2009 My side to side channel lock is not engaging at all. When I click on the engage (red) button -- nothing (no clicks at all). So it appears the magnet isn't knowing I tried to engage. The top to bottom channel lock works fine. I couldn't find anything in the manual on how to fix this. Any suggestions? Kari Link to comment Share on other sites More sharing options...
Quilting Heidi Posted May 25, 2009 Report Share Posted May 25, 2009 Kari did you try engaging from both sides of the machine. I would make sure it isn't a connection problem first. Link to comment Share on other sites More sharing options...
Kari Posted May 25, 2009 Author Report Share Posted May 25, 2009 Yes -- I doesn't engage from either side of the machine. Link to comment Share on other sites More sharing options...
yankiequilter Posted May 25, 2009 Report Share Posted May 25, 2009 I had a problem with a channel lock (can't remember which one), but I talked with Amy at APQS and she walked me through all of the things to check and how to make a minor adjustment. Give her a call in the morning and hopefully she will have it working for you in no time. Have your hex wrenches handy. Link to comment Share on other sites More sharing options...
LynnQuilts Posted May 26, 2009 Report Share Posted May 26, 2009 Have you checked the wheel itself, the one that has that channel lock on it? Once my channel lock had somehow gotten twisted on the wheel, and once I straightened it out, it made contact once again and worked fine. Link to comment Share on other sites More sharing options...
Quilting Heidi Posted May 26, 2009 Report Share Posted May 26, 2009 Kari I'm sure it is a simple adjustment. I don't have my manual here but give Amy a call and I'm sure she will have it working in no time. Link to comment Share on other sites More sharing options...
quiltmonkey Posted May 26, 2009 Report Share Posted May 26, 2009 Also, try scooching the mylar table top around a little bit. The table could have moved off center. If it's not set right then the channel lock magnets won't catch properly on the table where the magnetic strip is. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.