PeggyB Posted October 31, 2009 Report Share Posted October 31, 2009 my table was set at the lowest setting and I went to raise it and I hear one click but nothing happens. Does anyone have ideas on what is wrong? thanks, PeggyB Link to comment Share on other sites More sharing options...
Quilter 4 Jesus Posted November 1, 2009 Report Share Posted November 1, 2009 Peggy I'm sorry you are not getting any responses to your question. I would only be able to suggest checking all the wires going to the motor, each leg, and at the plug in. After that maybe unplug the unit for 10 minutes and try again. Also if using a power strip maybe change it out with another one, sometimes one outlet on them can stop working. Good luck, Link to comment Share on other sites More sharing options...
LindaB Posted November 1, 2009 Report Share Posted November 1, 2009 Several years ago we had a power surge in my studio that blew the power strip and also blew the fuse on my HL....check to see if the fuse is blown and replace.....also call Amy tomorrow and she can help you if it's not the fuse....Good luck..... Link to comment Share on other sites More sharing options...
LadyLake Posted November 2, 2009 Report Share Posted November 2, 2009 Peggy, Many of the staff were working the APQS booth at the AQS Expo in Des Moines until Sat eve -- if your question doesn't get answered online today, call APQS. Link to comment Share on other sites More sharing options...
dtreusch Posted November 2, 2009 Report Share Posted November 2, 2009 You can also check that none of the air tubes are getting pinched. I had something similar when I first got the hydraulic lift on my Millie. The machine would go up, but it wouldn't go down. The problem was that a tube was getting pinched in one of the trusses. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.