vally Posted September 15, 2018 Report Posted September 15, 2018 My up and needle was out of sync. Millie was still sewing along but frustrating when pulling up the bobbin thread. Problem solved. Called Apqs and they sent me a pdf on how to correct the problem. Who knew there was a rotating magnet behind a circuit board.My magnet was floating not screwed on. It was easy to do. Next will be clean the motor brush.
apylinski Posted January 4, 2019 Report Posted January 4, 2019 Mine just did the same thing. Angie sent me the pdf file also. Going to work on it tomorrow. I’m hoping it is an easy thing. I don’t know how to share the pdf file.
Kueser Posted January 5, 2019 Report Posted January 5, 2019 Angie, why not put the pdf on the web site under education????
apylinski Posted January 5, 2019 Report Posted January 5, 2019 I did mine last night. It wasn’t too hard at all.
Recommended Posts
Archived
This topic is now archived and is closed to further replies.