Hitomi Posted December 13, 2010 Report Share Posted December 13, 2010 I got this job from a friend. She hand dyes large flat sheets and she wants me to quilt it for a bedspread. When I open it up, it has a rolled hem on both side seams and bottom and another 3 inch rolled hem on the top. (It's a flat sheet). Should I cut all the hem seams off before quilting? I'm thinking it may be short. Any advice. I will be using 108" 200 thtread count white bleach muslin for my backing. Thinking about Quilter's dream for batting. Help?? Link to comment Share on other sites More sharing options...
sspingler Posted December 13, 2010 Report Share Posted December 13, 2010 When I use sheets (for backings and comforters) I always unsew the seams then wash at least 3 times using vinegar in the final rinse to remove any leftover chemicals. I never cut the seams off. Link to comment Share on other sites More sharing options...
Gail O Posted December 13, 2010 Report Share Posted December 13, 2010 If you don't "unsew" the seams or cut them off, the sheet won't roll on the leaders evenly - it will be thicker at the ends than the rest of the length and cause puckering and pleats. Used sheets for practise when I got my machine, and learned this the hard way. g Link to comment Share on other sites More sharing options...
Quilting Heidi Posted December 13, 2010 Report Share Posted December 13, 2010 If it were wide enough I would just sew a new seam and then cut off the french seam. Link to comment Share on other sites More sharing options...
witha'K'quilting Posted December 13, 2010 Report Share Posted December 13, 2010 I use flat sheets as backing quite a lot. I pin the top and bottom of the flat sheet to the leaders. If you pin the sides..then you get the wonkiness when rolling. I see no problem in quilting the whole top as long as you pin it on with the 3" rolled hem on the top leader. Cant wait to see it! Link to comment Share on other sites More sharing options...
Darlene Epp Posted December 14, 2010 Report Share Posted December 14, 2010 If in doubt, ask the customer. :cool: Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.